Dash 8-300
******************************
* DASH 8-300 How to fly *
******************************
– Enter via the hole on the left side of the fuselage
– Press 0 (on the numpad) and wait for the startup (~20s)
– Needs sufficient runway and obstacle clearance for takeoff
Controls:
WASD – Pitch / Roll
1 – Engine Power +
2 – Engine Power –
3 – Wheel Brake (Button)
4 – Flaps up
5 – Flaps down (0° – 8° – 16° – 24°)
6 – Gear up / down
7 – Elevator Trim up
8 – Elevator Trim down
9 – Parking Brake (Switch)
0 (Numpad only) – Engine / Systems Master
————————————————————
This airplane is designed to feel like a real commercial turboprop. It takes some practice time to get used to, but once you get the hang of it, it provides a satisfying flying experience.
– The engines, like real turboprops, take a few seconds to reach the desired power setting. Handle the throttle with care.
– The props spin at a speed of up to 3000 RPM, any collision when running will likely cause problems with the wing parts.
– Keep the power above 50% in the air, otherwise the plane will stall. Always trim for your current speed (buttons 7 & 8).
– Make sure the power is set to idle before turning off the engines!
Creation by LeftPlaying 2019
Special thanks to the modpack team and DasEtwas for the wing parts, without which this project wouldn’t have been possile.
Airport in the video: Heaawk International Airport by Heaawk
Required items:
Click the title to search on this site.
Additional Pipes by Lord Pain — Steam Workshop
Plates by Lord Pain — Steam Workshop
The Modpack — Steam Workshop
The Modpack Polygons — Steam Workshop
The Modpack Polygons Glass — Steam Workshop
The Modpack Polygons UltraLight — Steam Workshop
Wings — Steam Workshop
Interactive Parts Mod by Lord Pain — Steam Workshop
