Camera Drone GX1050
The Camera Drone GX1050 is a state of the art flying device designed by BlueFlame with input from ScrapMan. This is by far
the most stable camera drone I have made and it works extrodinarily well. It has been updated from the GX1000 because the gyroscope in that version got patche out by the devs, this one should work the same so nothing changed there.
To use it properly, knowledge and practice are required. I recommend giving yourself a
headstart by reading the description.
Controlls:
1&2 = Altitude controll
3&4 = Yaw
5&6 = Strafe/Pitch
7&8 = Strafe/Roll
9 = Neutral thrust
0 = Switch modes
Top buttons = Angle down seats 45 degrees
Bottom buttons = Emergency shutoff
Modes:
This craft is designed to have 2 mode, the
pitch/roll mode and the strafe mode. The pitch/roll mode is default on, to switch to the strafe mode just press the 0 key. To go back just hit the 0 key again. When any of the connected seats is in strafe mode the
gyroscope in the center will be activated. This allows you to keep level while doing all your nice pans, zooms and turnaround. (Especialy turnarounts cuz that throws it off axis.)
Extra features:
Scrapman told me the bottom of the seat
obstructs the view. To compensate I added a system that angles down the seats, just hit one of the switches on top of the craft and the seat angle down 45 degrees so you can get nice and high angle shots of your creations.
Ever fallen out of a creation and couldn’t
get back up? Well, now you don’t need to worry anymore! When you fall out just shoot one of the bottom switches with a spudgun and the drone will shut off
completely. To start it back up again hit the button again or respawn it on the lift, just make sure to turn it off first when hitting the button again. You can see if the emergency shutoff is on by looking at the orange logic gate somewhere on the drone.
Recommended keybinds:
1 = Y
2 = H
3 = G
4 = J
5 = Arrow up
6 = Arrow down
7 = Arrow left
8 = Arrow right
9 = T
0 = U
This gives you 2 extra arrow pads to put
your hands on. You don’t need to replace the numbers, because you can add multiple keybinds to 1 function.
The central gyroscope is on my steam
workshop for if you want to use it.
