Internal Filtration Controller
Parallel filtration controller for in unit use.
This controller has been designed to be used in the IC slot on the filtration device itself.
It is to be used when the filtration is set up in a parallel configuration with the other devices.
It will detect the filter cartridge that has been installed and start when the set amount of gas is detected at the input.
A diode slide can be connected to d0: to display the status of the installed cartridge.
A coolant pump can be connected to d1: to cool the storage tank to the specified temperature.
The filtration will shut off when the cartridges are empty, when the storage is full or when there is not enough gas to filter.
Setup:
Must be used in the filtration device slot.
d0: diode slide (optional)
d1: volume pump or valve (optional)
25/5/2023 Updated for infinite filters
