Bell Aircraft V280 / USCG
I know you need this, I hope you like this.
I’ve updated its avionics, so now you can fly this more easier.
[Engine start]
1. push "↓" to set minimum the collective
2. turn the key on
[VTOL/STOL take off]
1. VTOL:set throttle 40 / STOL:set throttle 20~30
2. wait until engine rps stabilizes
3. push "↑" to increase collective gently.
note : angle of engine nacelle is automatically controlled to avoid the blades hits ground.
[VTOL/CVM to airplane mode]
1. just push "3"
note : CVM = conversion mode
[airplane mode to VTOL/CV]
1. push "4" and pray your god to avoid fatal gyro issue.
[Cruise]
1. fly gently or you’ll die.
2. use "yaw" mainly to change direction.
[Autopilot Course]
0. it is not broken, please use your brain 100% or read manual
1. enter way point (large keyboard)
2. find waypoint manager and touch "set"
3. turn on "AP master" and "AP course"
4. you can override aircraft control
note : waypoint manager has 3 slot of memorize waypoint
note : waypoint and course will be shown in navigation screen
[Autopilot ALT hold]
1. enter target alt in ft (small keyboard)
2. turn on "AP master" and "AP ALT hold"
3. you can override aircraft control
[Rescue]
1. you have a "targeting pod" to find&mark the survivor,
push "1" to memorize (mark) the pointing coordinates in XY.
you can share the position data by TADIL.
2. the rescue whist can controlled from rescue harnesses and can in/out by pushing "5 & 6".
the harnesses also have an aircraft controls (pitch and roll)
[Other features]
1. the winch can controlled from cockpit.
"5" for cable up, "6" for cable down, "5&6" to connector on/off
—————————————————————-
DO NOT REUPLOAD FOR ANY REASON
