1×2 Configurable Engine Monitor
1×2 Configurable Engine MonitorThank you all for weekly top 1!(for a bit xD)
FEATURES
- For use with 1×2 monitors
- Configurable engine revolution units (RPS/RPM)
- Configurable engine temperature units (˚C/˚F)
- Configurable maximum fuel capacity
- Configurable fuel consumption units (L/s, L/m, G/s, and G/m)
- Configurable fuel consumption calculation period
- Configurable low fuel and engine overheat warning thresholds
- Displays whether the engine is off, starting, or running
HOW TO USE
- Connect all logic nodes
- If using an ECU, the starter and throttle nodes should be connected to the ECU’s output, and ideally to the air manifold if using modular engines
- Configure using the microcontroller properties
- Maximum fuel must be input in properties in liters, regardless of the selected fuel consumption unit
- If using infinite fuel, enable the option in properties to allow the engine run indicator to function properly (if not using infinite fuel disable this for a more accurate readout based on fuel consumption)
MORE INFO
- Fuel consumption calculation period controls how frequently fuel consumption is calculated and updated on the monitor, so if you don’t know what to set it to 5 seconds is a good starting point
- Feel free to use this in your creations, but please link back to this page if you upload them, and avoid editing the Lua
- Feedback is appreciated – please report any problems in the comments
- Feel free to leave a like if you enjoy using it
