DAF Standaardbus – HTM Livery
This is based on the 60s DAF Standaardbus that was used throughout The Netherlands, this one is in HTM Livery, HTM being the company who runs almost all transports within The Hague in Zuid-Holland.
NOTE: This is an old vehicle being uploaded, with minor patches and reworks, it is from before I even learnt how to use modular engines. It still works well, don’t get me wrong, but it isn’t to my recent build standard, this simplified workshop upload reflects that
SW Unit cost: $41,044
Length: 11.5m
Width: 2.75m (excl mirrors)
Height: 3.25m
Mass (excl fuel): 3,269.75units
Top speed: land: ~80km/h real, 103km/h with higher speed engaged (SEE INSTRUCTIONS)
Fuel capacity: 703.25L
Gears: 5 (1 reverse, 1 neutral, 3 drive, 4th gear only reduces steering )
Crew capacity: 32 (1 driver, 31 stormlink passengers)
Additional features:
– Working destination screen with bus number and some locations
– Simple kneeling mechanism
– Side and rear view mirrors
– Decorative card readers which light up
– 1 rear side exit
– 1 top emergency hatch
– basic accessible engine bay
– Basic aid and repair equipment
Important Information
Stormlink compatible! 31 seats
The 4th gear doesn’t make the bus faster, it only reduces steering sensitivity, ideal for highway
CAREFUL OFFROADING PLEASE
How to make the bus faster:
– Go to the rear of the bus
– Open the engine compartment
– Enable "enable higher speeds"How to get the bus going:
– Turn the "Engine" key ON
– Turn the "Handbrake" key ON
– Ensure "Bus doors" is depressed
– shift into gear and goHow to pull properly into a stop
– Use right hand signals to announce your turn
– Snow down to a complete stop
– Enable both turn signals
– Open bus doors
– Once done, close doors and use the right signals to announce your maneuver.
DO NOT RE-UPLOAD OR MODIFY WITHOUT MY PERMISSION
Part of the minor releases
