Skymods

Stormworks: Build and Rescue Mods Catalogue

ENDAIR E190 E2 [Stormlink Compatible]

Uploaded ·

If you liked this item, please rate it up on Steam Workshop page.

Author: EnderPilot

Last revision: 23 Apr, 2021 at 21:53 UTC

File size: 5.64 MB

On Steam Workshop

Description:
ENDAIR E-190 E2

The ENDAIR E-190 E2 is a passenger Regional aircraft developed by EPVIN Aviation Company
It has a Top speed of 290Knots, has a range of over 300KM. Also features a realistic cockpit!
The configuration is 2-2 in economy class and a 2-2 in business

NOTE: PLEASE DO NOT MODIFY OR RE-UPLOAD THIS VEHICLE


CAPACITY: 48 Passengers

Tested to be lag and Multiplayer friendly while holding great shape and performance!

COCKPIT FEATURES:
  • Analog and Digital Artificial horizon
  • EICAS Monitoring systems
  • HSI Diagram
  • Map
  • Fuel consumption Calculator
  • Radio comutication for both pilots
  • Autopilot, Altitude hold, Roll stabilisation
  • a blackbox and flight tracking channel with frequency set to 19
  • extendable-retractable Flaps
  • extendable-retractable Spoilers
  • extendable-retractable Landing gear
  • Take-Give control to Captain or First Officer
  • Evacuation Mode
  • Fire supression systems
  • 3 hydraulic systems
  • Cabin light and heating controls
  • Nav, Strobe, Landing, Taxi and beacon lights
  • Seatbelt and No Smoking Panel and warning
  • Reverse thrust

    How to use the PFD screen:
    there is a 1×1 on the center console that has 3 options
    1. NAV = Which has the Map and gps
    2. EICAS = Which has the engine status
    3. HSI = Which has a diagram of a conventional heading indicator
    You can select either one by pressing them on the screen!

    HOW TO GET IN:

    Go to any of the front doors then press the button next of the small window
    and then jump and grab the handle next to the door button and bring your self up

    STARTUP PROCEDURE:

    1. Open Battery and avionics
    2. Open All 2 PFD Controlers
    3. Open all Hydaulic systems
    4. Open EN1 and EN2 Fuel cutoff and pumps
    5. Open EN1 and EN2 Starters
    6. Open Beacon

    APU STARTUP PROCEDURE:

    1. Open APU Fuel pump
    2. Open APU Starter

    AUTOPILOT SETUP:

    Tip Take a moment before takeoff to input your desired coordinates and Altitude to the aircraft!

    1. Set up your waypoint coordinates on the Autopilot Coordinates Panel
    2. Press the Engage Autopilot Button
    3. Enable FD

    ALTITUDE SETUP:

    1. Set up your desired Altitude on the Altitude Hold Panel
    2. Press the ALT HOLD Button
    3. Enable FD

    BLACKBOX AND FLIGHT TRACKING:

    On channel: 19 there is a compisote signal transmition that holds flight information

    THROTTLE:

    *120% Takeoff
    *110-80% Cruise [Its most eficient at 110-120%]
    *25% Landing
    *11% Taxiing

    CREDITS

    3d MAP by Buunuu
    CONSUMPTION 1×1 By krimwand
    AH (modded) by Markers662
    HSI by hally

    Consider leaving a Rating and a Comment if you like the creation.
    If you find any Bugs please report them down below
Download

Tags: