ENDAIR 777-9X

If you liked this item, please rate it up on Steam Workshop page.

Author: EnderPilot

Last revision: 18 Mar, 2021 at 13:01 UTC

File size: 25.11 MB

On Steam Workshop

Description:

The ENDAIR 777-9X is a passenger aircraft developed by EPVIN Aviation Company
It has a Top speed of 240 Knots, Has a range of over 1000KM thanks to the new GE9X engine and 280.000L of fuel spited into 4 tanks. Also features a realistic cockpit!

The configuration is 2-4-2 in economy class, 1-1-1 in business featuring a working entertainment system and 1-1 in first class featuring both entertainment systems and Shower access
Also features a on board Bar for first and business class
and has a cargo bay And an avionics bay under the cockpit

[Requires modded workbench or custom mission to spawn]

[It is recommended to not spawn or land to very small airports]

• Digital Artificial horizon
• EICAS monitoring system [as featured in a real Boeing]
• Map
• Fuel consumption Calculator
• Radio comutication for both pilots
• Autopilot, Altitude hold, Roll stabilisation
• a blackbox and flight tracking channel with frequency set to 19
• extendable-retractable Flaps
• extendable-retractable Landing gear
• Take-Give control to Captain or First Officer
• MCAS Safety System [as featured in a real Boeing]
• Evacuation mode
• Fire supression safety systems
• 3 hydraulic systems
• Cabin light and heating controls
• Nav, Strobe, Landing, Taxi and beacon lights
• Seatbelt and No Smoking Panel and warning

  How to use the PFD screen:
  there is a 1×1 on the center console that has 3 options
  1. NAV = Which has the Map and gps
  2. EICAS = Which has the engine status as well as the Gear and Wingtips indications
  3. INF = Which has a diagram of the aircraft indicating locked or unlocked exits-doors
  You can select either one by pressing them on the screen!

  If you are getting a master warning check:

• If you have extended your WingTips
• If you have a fire Warning
• If you have a failure message in your PFD
  Entertainment systems:
• You have to seat down and then look to your left (or right) for a small 1×1 screen, You can select the mode you want by pressing any of the options
  HOW TO GET IN:
• You can use the "Home" button on your keyboard and No-Clip your self in

  OR

• Go to any of the front doors then press the button below the small window
  and then jump and grab the handle next to the door button and bring your self up
  STARTUP PROCEDURE:

  1. Open Battery and avionics
  2. Open All 3 PFD Controllers
  3. Open all Hydraulic systems
  4. Open EN1 and EN2 Fuel cutoff and pumps
  5. Open EN1 and EN2 GEN and BUS
  6. Open EN1 and EN2 Starters
  7. Monitor EICAS Screen until engines are stabilized
  8. Open Beacon
  9. Extent Wingtips [before takeoff]

  APU STARTUP PROCEDURE:

  1. Open APU Hydraulic pumps
  2. Open APU Auto-Starter

  AUTOPILOT SETUP:

  Tip Take a moment before takeoff to input your desired coordinates and Altitude to the aircraft!

  1. Set up your waypoint coordinates on the Autopilot Coordinates Panel
  2. Press the Engage Autopilot Button
  3. Enable FD

  ALTITUDE SETUP:

  1. Set up your desired Altitude on the Altitude Hold Panel
  2. Press the ALT HOLD Button
  3. Enable FD

  BLACKBOX AND FLIGHT TRACKING:

  On channel: 19 there is a composite signal transmition that holds flight information

  THROTTLE:

  * 130% Takeoff
  * 120-100% Cruise [Its most eficient at 120%]
  * 50% Landing
  * 11-12% Taxiing

  Disclaimer
  This is a pretty hefty aircraft so it might slow down the game

  CREDITS

  Billy-blij-1-2-3: Has offered great help with the New ALT HOLD AP Microcontroler!

  3d MAP by Buunuu
  CONSUMPTION 1×1 By krimwand
  4 dials 1 display by michubushimax9
  GPS NAVIGATION GD By MrNJersey
  Advanced PFD by Ping|Archimaede

  Consider leaving a Rating and a Comment if you like the creation.
  If you find any Bugs please report them down below