J – 55 "Envoy"

If you liked this item, please rate it up on Steam Workshop page.

Author: RootinTootinCowboy

Last revision: 27 Apr, 2020 at 04:25 UTC

File size: 4.54 MB

On Steam Workshop

Description:
J – 55 "Envoy"

The J – 55 "Envoy" is a long range, heavy-lift freighter with a range of ~180km fully loaded. Built for remote airstrips and harsh conditions, the Envoy is equipped with a 200 SWatt Generator powered by its powerful 2800 hp Cyclone V engines. In addition there are sleeping quarters and a small crane.

*Added Heaters & squashed bugs*

Features:
• Propeller Sync Clutch (One engine can drive both propellers, not reccomended).
• Twin 2800 HP Cyclone V, 24 cylinder engines.
• VHF Radio
• Radio Transponder by PenguinO
• Nose Door w/ Ramps
• Crane
• 2,100 kg cargo capacity (~about 3 WN 400i Hatchbacks)
• 200 SWatt Genset
• 180 km Range
• Cockpit by Penguin O
• Autopilot by jbaker86
• Realistic Engine Start

Startup: (All on overhead)
1. Close Battery Breaker
2. Avionics Master Switch On
3. Fuel Pumps
4. Start Engines – Use Prop Condition lever to increase speed AFTER increasing throttle.

Using the Large Genset: (On center Pedestal)
1. Increase throttle to 50%
2. Disengage Propellers (to the left of co-pilot)
3. Adjust throttle as necessary

Notes:
-Avoid the Yellow Rectangle, it’s wonky physics area, If you fall through just crouch and walk out only happens the gear is down, so don’t about falling out while flying.
-Don’t rev the engines without load they’ll catch fire
-Take off speed is about 85 kts
-Use flaps to loose speed for landing