Yasen MM
The Yasen class, Russian designations Project 885 Yasen and Project 885M Yasen-M (Russian: Ясень, lit. ‘ash tree’, NATO reporting name: Yasen)
Good Luck!
The Yasen-class submarines were designed by the Malakhit Central Design Bureau, which was formed by the combination of SKB-143 and TsKB-16. Work on the initial design was scheduled to start in 1977 and be completed in 1985. Malakhit is one of the three Soviet/Russian submarine design centers, along with Rubin Design Bureau and Lazurit Central Design Bureau.
Construction on the first submarine started on 21 December 1993, with its launch slated for 1995 and its commissioning for 1998. However, the project was delayed due to financial problems and it appeared during 1996 that work on the submarine had stopped completely. Some reports suggested that as of 1999 the submarine was less than 10 percent completed. In 2003 the project then received additional funding and the work of finishing the submarine continued
Before starting the campaign, wait for the reactor to fully warm up. Then turn on the main turbine control and slowly pull the handle.
Also-raise the radar mast before using the radar!
Diving:
Close all hatches, fill up all ballast (neutral ballast is configured) and dive
Surface:
Blow all the ballast and float up
Depth Hold:
Set the depth (positive only) to "Set Depth"
then click on the "Auto Depth" button
Encryption Machine:
Receiving:
to start, set the codes:
(disabled = 1)
Code 1: 1
Code 2: 4
Code 3: 8
(For example, take code 148)
Attention! The code on the receiving and transmitting sides must be the same!
Then set the frequency at which we want to receive
And we start receiving the message:
the encrypted code will appear on the screen and the letter that was encrypted will appear below
Transmission:
Set the same code (148) and set the frequency
Then click on the "Transmit" button
And start transmitting:
there is a keyboard Below
Click on the letter you want to pass (you need to hold it for a short time)
Just above you will see the number of the letter you are passing
Torpedoes:
Launch:
In "Bearing", set the course you want to aim the torpedo at, or you can switch the bearing to the compass sensor and roughly aim the torpedo at the target
Use the "W-S" buttons to set the depth of the torpedoes
On the "A-D" buttons, you set the pre-emption on which the target is moving
Then open the front covers of the torpedo tubes (this can be done from the torpedo control station – hold the "Open/Close Torpedo Tubes" button
Torpedoes are ready!
There are torpedo launch levers to the left of the seat
Torpedoes in the water! They follow a given course and depth in search of a target
Then close the front covers with the "Open/Close Torpedo Tubes" button (push)
And done
Torpedo tubes can be reloaded!
All systems used:
MoBo Naval Tracking Map – https://steamcommunity.com/sharedfiles/filedetails/?id=2308050926&searchtext=
homing torpedo – https://steamcommunity.com/sharedfiles/filedetails/?id=2046722118&searchtext=G.T.R.K.T.
Infinite generator 4KW – https://steamcommunity.com/sharedfiles/filedetails/?id=2093177039&searchtext=4+kw
Radar Controller – https://steamcommunity.com/sharedfiles/filedetails/?id=1749474737&searchtext=radar
NJ Navigation Waypoint Autopilot – https://steamcommunity.com/sharedfiles/filedetails/?id=1997983465
*LUA* navigation map – https://steamcommunity.com/sharedfiles/filedetails/?id=1800753475&searchtext=map
